RLC 521560.03 – Right Outer Worklight on Rear of Roof or Right Turn-Signal Light on Rear of Roof (SAE), Voltage Too High

RLC 521560.03 (RLC )

Code: 521560.03



This diagnostic trouble code is generated if a voltage higher than the expected value is registered at the output to the right outer worklight on the rear of the roof or right turn-signal light on the rear of the roof (SAE). This indicates that the circuit is open or shorted to 12 volts.


When this error is detected, the control software may experience limited or no functionality of the worklight or the turn-signal light.


  • Inspect Light Circuit:
    • Check the wiring and connectors associated with the right outer worklight or right turn-signal light for signs of open circuits or shorts to 12 volts. Look for damaged insulation or exposed wires. Repair or replace any compromised wiring.
  • Verify Voltage Regulation:
    • Ensure the voltage regulator is functioning correctly and maintaining proper voltage levels. Replace the regulator if it is faulty.
  • Test Lights:
    • Test the right outer worklight or right turn-signal light to ensure they are not damaged or causing the voltage increase. Replace any faulty light components.
  • Check Power Supply:
    • Ensure the power supply to the lights is stable and within the specified range. Inspect for any issues that could cause an overvoltage condition.


Excessive voltage can damage the lights and associated circuitry. Regular inspection and maintenance of the electrical system are essential to prevent such issues.

Control Units: John Deere

John Deere Parts
John Deere Logo