Description:

This error code indicates that the calibration data for the suspended front axle (SFA) control unit is invalid or incomplete. This can occur due to improper calibration procedures, corrupted data, or software issues within the control unit.

Reaction:

When this error code is triggered, the suspension system may not function correctly, leading to poor handling, a rough ride, and potentially unsafe operating conditions.

Recommendations:

• Recalibrate the System:
  • Perform a full recalibration of the SFA system using the manufacturer’s recommended procedure. Ensure that all steps are followed accurately.
• Check Calibration Data:
  • Verify that the calibration data is complete and correct. If the data is corrupted, re-enter or reload the calibration parameters.
• Update Control Unit Software:
  • Ensure the SFA control unit firmware is up-to-date. Update the software if necessary to correct any bugs that might affect calibration data.
• Inspect Control Unit and Sensors:
  • Inspect the control unit and position sensors for any signs of damage or malfunction. Replace any faulty components.
• Consult Technical Support:
  • If the issue persists, consult technical support or the manufacturer for further assistance in resolving the calibration fault.

Note:

Regular calibration and maintenance of the SFA system are crucial for optimal performance. Ensure all software updates and calibration procedures are performed as per the manufacturer’s guidelines.