SSU 523822.07 – SSU Calibration Fault / Wheel Angle Sensor-Flow Meter Range Low
SSU 523822.07 (SSU )
Code: 523822.07
Shortcode:
Description:
This diagnostic trouble code (DTC), SSU 523822.07, is triggered when the Steering System Control Unit (SSU) detects that the wheel angle sensor-flow meter value count is too low during the SSU calibration procedure. This indicates that the sensor-flow meter is not providing adequate readings.
Reaction:
When this error is detected, the steering system may not calibrate correctly, leading to inaccurate steering control and potential safety issues.
Recommendations:
When this error is detected, the steering system may not calibrate correctly, leading to inaccurate steering control and potential safety issues.
Note:
Verify Sensor and Flow Meter Functionality:
- Check the wheel angle sensor and flow meter to ensure they are functioning properly and providing accurate readings.
Inspect Sensor Connections:
- Inspect the wiring and connectors related to the wheel angle sensor and flow meter for signs of damage, loose connections, or corrosion.
- Ensure all connections are secure and free from contaminants.
Perform Calibration:
- Recalibrate the steering system following the correct procedure to ensure accurate readings from the wheel angle sensor and flow meter.
- Follow the manufacturer’s guidelines for the calibration process.
Update Software:
- Ensure that the SSU software is up-to-date. Apply any available firmware updates to improve calibration accuracy and system performance.
Replace Faulty Components:
- If the wheel angle sensor or flow meter are found to be defective, replace them with new, genuine parts.
Consult Technical Support:
- If the error persists after performing the above steps, consult technical support or the manufacturer for further assistance.