Description:

This error code indicates that the software for the Selective Control Valve Unit VI (SV VI) failed to execute within the allotted time. This can be due to software bugs, insufficient system resources, or hardware issues within the control unit.

Reaction:

When this error code is detected, the system will log the fault and may display a warning on the operator’s console. The functionality of the SV VI may be compromised, potentially affecting the overall performance of the equipment.

Recommendations:

Restart Control Unit:

• Restart the SV VI control unit to see if the issue resolves.

Update Software:

• Ensure that the control unit software is up-to-date with the latest versions provided by John Deere.
• If an update is available, install the latest firmware and software updates.

Check System Resources:

• Verify that the control unit has sufficient system resources (memory, processing power) to execute the software.

Inspect Hardware:

• Check the hardware of the control unit for signs of damage or failure.
• Replace any faulty components as necessary.

Consult Technical Support:

• If the issue persists after performing the above steps, consult John Deere technical support for further assistance.

Monitor System:

• After performing corrective actions, monitor the system to ensure the fault does not reoccur.

Note:

Regular updates and maintenance are crucial to prevent software execution issues. Ensure that all system components are functioning correctly and that the control unit has adequate resources to perform its tasks.