SV7 004084.07 – SV VII Not in Float Position

SV7 004084.07 (SV7 4084.07)

Code: 004084.07

Shortcode: 4084.07

Description:

This error code indicates that the Selective Control Valve VII (SV VII) is not going into the FLOAT position as expected. This condition can occur due to mechanical or electrical issues affecting the valve operation.

Reaction:

When this error code is detected, the system may experience issues with hydraulic functions that rely on the FLOAT position of SV VII, potentially leading to improper equipment operation.

Recommendations:

Inspect Valve Mechanism:

  • Check the mechanical components of SV VII to ensure they are not obstructed or damaged. Clean, lubricate, or replace parts as necessary.

Verify Control Signals:

  • Ensure that the control signals being sent to SV VII are correct and that the valve is receiving the proper commands to move to the FLOAT position.

Software Calibration:

  • Perform a software calibration of SV VII to ensure it is correctly configured to reach the FLOAT position.

Consult Technical Support:

  • Contact John Deere technical support if the issue persists after performing the above steps. They can provide further guidance and advanced diagnostic procedures.

Note:

Regular maintenance and calibration of hydraulic components are essential to ensure they function correctly. Addressing any mechanical or signal issues promptly can help maintain optimal operation.


Control Units: John Deere

John Deere Parts
John Deere Logo