UIC 001713.15 – Hydraulic Oil Filter Dirty

UIC 001713.15 (UIC 1713.15)

Code: 001713.15

Shortcode: 1713.15

Description:

This diagnostic trouble code (DTC) UIC 001713.15 is generated when the filter alarm level 1 switch at the hydraulic oil filter closes for more than three seconds at a transmission oil temperature above 28 °C (82 °F) and an engine speed of more than 700 rpm. The switch closes at a differential filter pressure of 350 kPa (3.5 bar; 51 psi) ± 20 kPa (0.2 bar; 2.9 psi), indicating that the hydraulic oil filter is contaminated.

Reaction:

When this error occurs, the control unit may limit the hydraulic system’s performance to prevent further contamination and potential damage.

Recommendations:

  • Change Hydraulic Oil Filter:
    • Replace the hydraulic oil filter with a new one as the current filter is contaminated.
  • Inspect Hydraulic System:
    • Check the hydraulic system for any signs of contamination or debris that might have caused the filter to become dirty.
  • Monitor Differential Pressure:
    • After replacing the filter, monitor the differential pressure to ensure it remains within acceptable limits.
  • Consult Technical Support:
    • If the issue persists, contact John Deere technical support for further assistance and potential solutions.

Note:

Regular maintenance and timely replacement of the hydraulic oil filter can help prevent contamination and maintain system performance.


Control Units: John Deere