Description:

This diagnostic trouble code (DTC) UIC 001713.16 is generated when the filter alarm level 2 switch at the hydraulic oil filter closes for more than three seconds at a transmission oil temperature above 28 °C (82 °F) and an engine speed of more than 700 rpm. The switch closes at a differential filter pressure of 425 kPa (4.25 bar; 62 psi) ± 25 kPa (0.25 bar; 4 psi), indicating that the hydraulic oil filter is significantly restricted.

Reaction:

When this error occurs, the control unit may severely limit the hydraulic system’s performance or even shut it down to prevent damage due to restricted oil flow.

Recommendations:

• Change Hydraulic Oil Filter:
  • Replace the hydraulic oil filter immediately as it is significantly restricted and potentially causing system issues.
• Inspect Hydraulic System:
  • Check the hydraulic system for any signs of severe contamination or debris that might have caused the filter to become restricted.
• Monitor Differential Pressure:
  • After replacing the filter, monitor the differential pressure to ensure it remains within acceptable limits.
• Consult Technical Support:
  • If the issue persists, contact John Deere technical support for further assistance and potential solutions.

Note:

Timely replacement of the hydraulic oil filter is crucial to maintaining the health and performance of the hydraulic system. Regular monitoring and maintenance can help prevent severe restrictions.