Description:

This error code indicates that the voltages in channel 1 and channel 2 of the wheel angle sensor are not in the correct ratio. The signal voltage of sensor 2 should be 1/2 of the signal voltage of sensor 1. A difference of 0.4 volts or more suggests a problem with the sensor’s accuracy, despite the XSC control software measuring the value within the acceptable range.

Reaction:

When this error is detected, the control software will limit or disable certain functions to prevent potential malfunctions related to incorrect wheel angle readings.

Recommendations:

Inspect Sensor Wiring:

• Check the wiring harness connected to the wheel angle sensor for any signs of damage, disconnection, or corrosion. Repair or replace any damaged wiring.

Test Sensor Functionality:

• Use diagnostic tools to test the functionality of the wheel angle sensor. Ensure it is operating within specified parameters and that the voltages between channels 1 and 2 are in the correct ratio.

Verify Sensor Mounting:

• Ensure the sensor is securely mounted and properly aligned. Loose or misaligned sensors can give inaccurate readings.

Check for Electrical Interference:

• Ensure there is no electrical interference affecting the sensor. Inspect nearby components for potential sources of interference.

Replace Faulty Sensor:

• If the sensor itself is determined to be faulty, replace it with a new, manufacturer-approved part.

Consult Technical Support:

• If the issue persists, consult technical support for further assistance.

Note:

Ensuring the correct ratio between the voltages in channel 1 and channel 2 of the wheel angle sensor is essential for accurate vehicle steering performance. Regular checks and prompt repairs can prevent ratio-related issues from affecting system functionality.