Description:

This error code indicates that the suspension system is not responding to the raise command. The position sensor detects no upward movement for longer than 10 seconds, which may be caused by mechanical obstructions, faulty sensors, or issues within the hydraulic system.

Reaction:

When this error code is triggered, the suspension system will not raise as commanded, leading to potential handling issues and reduced ride comfort.

Recommendations:

• Inspect Hydraulic System:
  • Check the hydraulic fluid levels and ensure there are no leaks. Inspect the hydraulic pump and lines for proper operation.
• Check for Mechanical Obstructions:
  • Inspect the suspension system for any mechanical obstructions or debris that might prevent upward movement. Clear any obstructions found.
• Test Position Sensor:
  • Test the position sensor to ensure it is functioning correctly. Replace the sensor if it is found to be defective.
• Verify Solenoid Operation:
  • Check the raise command solenoid for proper operation. Ensure it is receiving the correct signals and replace it if necessary.
• Consult Technical Support:
  • If the issue persists, consult technical support or the manufacturer for further assistance in diagnosing and resolving the problem.

Note:

Regular maintenance of the hydraulic system and sensors is crucial for the proper functioning of the suspension system. Address any issues promptly to avoid further complications.