This error code, XSC 524055.12, indicates that a fault occurred when the software was launched. This startup issue can prevent the control software from functioning correctly, impacting overall vehicle operation.

READ MORE

This error code, XSC 524055.02, is generated when an error occurs while reading the internal module (EEPROM). This fault can affect the internal storage and retrieval of data, impacting the overall operation of the control software.

READ MORE

This error code, XSC 523925.09, indicates a data transfer problem between the XMC control software and the XSC control software. The issue could be due to intermittent or non-existent reception of one or more CAN messages expected by the XMC control software, potentially caused by a loose wire or other CAN BUS issues.

READ MORE

This error code, XSC 523826.14, is generated when no steering movement is detected at the front wheels despite a command being transmitted to the steering control valves. This indicates a potential malfunction in the steering wheel position sensor or the steering control system.

READ MORE

This error code, XSC 523826.01, is generated when a voltage below 0.5 volts is registered at channel 1 of the wheel angle sensor. This low voltage suggests a potential issue with the sensor or signal processing, which can disrupt normal operation.

READ MORE

This error code, XSC 523826.00, is generated when a voltage over 4.5 volts is registered at channel 1 of the wheel angle sensor. This high voltage suggests a potential issue with the sensor or signal processing, which can disrupt normal operation.

READ MORE

This error code, XSC 523824.21, is generated when the duty cycle at channel 2 of the steering wheel position sensor is less than 1%. This low duty cycle suggests a potential malfunction of the sensor or its signal processing.

READ MORE

This error code, XSC 523824.20, is generated when the duty cycle at channel 2 of the steering wheel position sensor is greater than 99%. This high duty cycle suggests a potential malfunction of the sensor or its signal processing.

READ MORE

This error code, XSC 523824.18, is generated when a frequency below 150 Hz is registered at channel 2 of the steering wheel position sensor. This low frequency suggests a potential issue with the sensor or signal processing, which can disrupt normal operation.

READ MORE

This error code, XSC 523824.16, is generated when a frequency of over 300 Hz is registered at channel 2 of the steering wheel position sensor. This high frequency indicates a potential issue with the sensor or signal processing, which can disrupt normal operation.

READ MORE

This error code, XSC 523824.10, is generated when a speed of over 400 rpm is registered at channel 2 of the steering wheel position sensor. This high speed indicates a potential issue with the sensor or signal processing, which can disrupt normal operation.

READ MORE