Description:

This diagnostic trouble code (DTC), SSU 523826.14, is generated when the wheel angle sensor (WAS) does not detect any steering movement even though the steering wheel position sensor (B138) transmits steering signals to the SSU. This indicates a discrepancy between the steering wheel input and the actual steering motion.

Reaction:

When this error is detected, the steering system may not respond accurately to steering inputs, potentially leading to issues with vehicle control and safety.

Recommendations:

Inspect Wheel Angle Sensor:

• Check the wheel angle sensor (WAS) for proper operation and signal transmission.
• Ensure the sensor is securely mounted and properly connected.

Verify Sensor Signals:

• Use diagnostic tools to verify the signals from both the wheel angle sensor (WAS) and the steering wheel position sensor (B138).
• Ensure that the signals are consistent and within the expected range.

Check for Mechanical Issues:

• Inspect the steering mechanism for any signs of looseness, wear, or mechanical play that could cause discrepancies in sensor readings.
• Tighten or replace any worn components as necessary.

Update Software:

• Ensure that the SSU software is up-to-date. Apply any available firmware updates to improve system performance and sensor synchronization.

Replace Faulty Components:

• If any of the sensors or related components are found to be defective, replace them with new, genuine parts.

Consult Technical Support:

• If the error persists after performing the above steps, consult technical support or the manufacturer for further assistance.

Note:

• Regular maintenance and inspection of the steering system can help prevent discrepancies between sensor readings.
• Ensuring accurate sensor alignment and calibration is crucial for reliable steering performance.