Description:

This diagnostic trouble code (TCU 524153.05) is generated if the control unit registers a resistance at the solenoid valve that does not correspond with the switch status of BG disk brake. This indicates that the solenoid valve’s circuit is open, leading to insufficient current flow.

Reaction:

When this error code is detected, the equipment may experience issues with the operation of the disk brake, leading to potential performance problems. The system might enter a protective mode to prevent further issues, resulting in limited operational capabilities or warnings displayed to the operator.

Recommendations:

1. Inspect Solenoid Valve Circuit:

• Check for Open Circuit: Inspect the wiring for any signs of disconnection or breaks in the circuit.
• Ensure Secure Connections: Make sure all connections are secure and free of corrosion.

2. Test the Solenoid Valve:

• Measure Current: Use a multimeter to measure the current at the signal input of the BG solenoid valve.
• Replace if Faulty: Replace the solenoid valve if it is not drawing sufficient current.

3. Examine Wiring and Connectors:

• Inspect for Damage: Check the wiring and connectors associated with the solenoid valve for damage or disconnection.
• Repair or Replace: Repair or replace any damaged components.

4. Verify Control Unit Functionality:

• Test Control Unit: Ensure that the control unit is correctly processing the solenoid valve signals.
• Update Software: Update the control unit software if necessary.

Note:

Maintaining the solenoid valve and its associated circuitry is crucial for accurate disk brake operation. Regular inspections and prompt repairs can help prevent issues related to low current readings.