Description:

This information for the operator (DTC) is generated when the engine has shut down while the ignition is still switched on, and the reverse drive lever is still in the forward or reverse position. For restarting, the reverse drive lever must be moved to the neutral position or the corner park position.

Reaction:

The engine cannot be restarted until the reverse drive lever is moved to the neutral or corner park position.

Recommendations:

Move Reverse Drive Lever:

• Move the reverse drive lever to the neutral position or the corner park position to allow the engine to restart.

Inspect Lever Position Sensors:

• Verify the sensors detecting the position of the reverse drive lever are functioning correctly.
• Replace any faulty sensors.

Check Operator Procedures:

• Ensure the operator is aware of the correct procedure for starting and stopping the engine, including the position of the reverse drive lever.

Consult Technical Support:

• If the issue persists, consult technical support for further diagnostic procedures.

Note:

Regular checks of the reverse drive lever and associated sensors can help prevent this issue. Proper operator training on the correct procedures for engine start and stop is crucial for smooth operation.