Description:

This operator information (DTC) is generated when the TIA control software activates the anti-jack-knife control in response to a change in the ratio of the front and rear axle operating speeds (with front-wheel drive disengaged). This feature is designed to prevent jack-knifing, which can occur under certain operating conditions.

Reaction:

The system activates anti-jack-knife control to ensure vehicle stability and safety.

Recommendations:

Monitor Operating Conditions:

• Be aware of changes in the ratio of front and rear axle operating speeds.
• Avoid situations that may lead to jack-knifing by adjusting driving speed and load distribution.

Inspect Front and Rear Axle Sensors:

• Verify the operation of sensors monitoring the front and rear axle speeds.
• Replace any faulty sensors to ensure accurate readings.

Check Front-Wheel Drive Engagement:

• Ensure the front-wheel drive system is functioning correctly and can engage/disengage as needed.
• Inspect the front-wheel drive mechanism for any mechanical issues.

Consult Operator Manual:

• Refer to the operator manual for detailed instructions on handling and preventing jack-knifing situations.

Consult Technical Support:

• If the issue persists or further assistance is needed, consult technical support for additional guidance.

Note: