XMC 000628.12 – Control Software Internal Fault

XMC 000628.12 (XMC 628.12)

Code: 000628.12

Shortcode: 628.12

Description:

This error code indicates that the control software is currently being programmed. The diagnostic trouble code appears during the programming process, which is normal and temporary.

Reaction:

When this error is detected, the control software will limit or disable certain functions until the programming process is complete. This ensures system integrity during the update.

Recommendations:

Wait for Completion:

  • Allow the programming process to finish. Do not interrupt the programming sequence.

Verify Successful Update:

  • After programming is complete, verify that the control software has been successfully updated and that the error code is no longer present.

Check for Additional Errors:

  • Once programming is complete, monitor the system for any additional error codes that may arise and address them accordingly.

Consult Technical Support:

  • If the error persists after programming, consult technical support for further assistance.

Note:

Interrupting the programming process can lead to incomplete software updates and potential system malfunctions. Always ensure that the programming process is allowed to complete fully before troubleshooting further.


Control Units: John Deere