Description:

This error code is generated if the duty cycle at channel 2 of the steering wheel position sensor is less than 1%. Although the value measured by the XSC control software is within the acceptable range, such a low duty cycle may suggest a potential issue with the sensor or its signal processing.

Reaction:

When this error is detected, the control software will limit or disable certain functions to prevent potential malfunctions related to incorrect steering wheel position readings.

Recommendations:

Inspect Sensor Wiring:

• Check the wiring harness connected to the steering wheel position sensor for any signs of damage, disconnection, or corrosion. Repair or replace any damaged wiring.

Test Sensor Functionality:

• Use diagnostic tools to test the functionality of the steering wheel position sensor. Ensure it is operating within specified parameters.

Verify Sensor Mounting:

• Ensure the sensor is securely mounted and properly aligned. Loose or misaligned sensors can give inaccurate readings.

Check for Interference:

• Ensure there is no electrical interference affecting the sensor. Inspect nearby components for potential sources of interference.

Replace Faulty Sensor:

• If the sensor itself is determined to be faulty, replace it with a new, manufacturer-approved part.

Consult Technical Support:

• If the issue persists, consult technical support for further assistance.

Note:

Regular maintenance and inspection of sensors and their connections are crucial for reliable vehicle operation. Addressing issues promptly can prevent duty cycle-related problems from affecting system performance.