Description:

This error code, XSC 000628.12, indicates that the control software is currently being programmed. The system requires that the programming process be completed before this diagnostic trouble code can be addressed. Attempting to address the fault during programming can result in incomplete or corrupted software installation.

Reaction:

During the occurrence of this fault, the control software will have limited or no functionality. The machine’s operations dependent on the control software will be halted or significantly impaired until programming is completed.

Recommendations:

Wait for Programming to Complete:

• Allow the programming process to finish without interruption. Interruptions can lead to further software issues.

Verify Programming Process:

• Ensure that the programming process is carried out according to the manufacturer’s guidelines.
• Monitor the progress to confirm that the programming completes successfully.

Post-Programming Checks:

• Once programming is complete, perform a full system check to ensure the control software is functioning correctly.
• Validate that all functions and systems dependent on the control software are operating as expected.

Consult Technical Support:

• If issues persist after programming, contact John Deere technical support for further diagnostics and solutions.
• Provide information about the programming steps followed and any anomalies observed during the process.

Note:

Ensuring the programming process is completed without interruptions is crucial for the stability and reliability of the control software. Regular updates and proper programming protocols help maintain the system’s efficiency and prevent such faults.