XSC 000709.16 – Steering Wheel Position Sensor, Frequency at Channel 2 Too High
XSC 000709.16 (XSC 709.16)
Code: 000709.16
Shortcode: 709.16
Description:
This error code, XSC 000709.16, is generated when a frequency of over 300 Hz is registered at channel 2 of the steering wheel position sensor. Despite this high frequency, the value measured by the XMC control software is within the acceptable range, indicating a potential issue with the sensor or signal processing.
Reaction:
When this fault occurs, the control software will exhibit limited or no functionality, impacting the accuracy and responsiveness of the steering system.
Recommendations:
nspect Steering Wheel Position Sensor:
- Check the steering wheel position sensor for any signs of damage or wear.
- Ensure the sensor is properly installed and securely connected.
Monitor Sensor Frequency:
- Use diagnostic tools to monitor the sensor frequency and verify if it exceeds the normal operating range.
- Compare the sensor frequency readings with those from the XMC control software to identify discrepancies.
Update Control Software:
- Check for and install any available updates for the control software to address potential bugs or signal processing issues.
Consult Technical Support:
- If the issue persists, contact John Deere technical support for further diagnostics and solutions.
- Provide detailed logs of the sensor frequency readings and any steps already taken to address the fault.
Note:
Maintaining the proper frequency of the steering wheel position sensor is essential for the accurate functioning of the steering system. Regular inspections and updates can help ensure system reliability.