XSC 523824.10 – Steering Wheel Position Sensor Channel 2, Malfunction

XSC 523824.10 (XSC )

Code: 523824.10

Shortcode:

Description:

This error code, XSC 523824.10, is generated when a speed of over 400 rpm is registered at channel 2 of the steering wheel position sensor. This high speed indicates a potential issue with the sensor or signal processing, which can disrupt normal operation.

Reaction:

When this fault occurs, the control software will exhibit limited or no functionality, affecting the accuracy and responsiveness of the steering system.

Recommendations:

Inspect Steering Wheel Position Sensor:

  • Check the steering wheel position sensor for any signs of damage or wear.
  • Ensure the sensor is properly installed and securely connected.

Monitor Sensor Output:

  • Use diagnostic tools to monitor the sensor output and verify if the reported speed exceeds the normal operating range.
  • Compare the sensor readings with those from the XMC control software to identify discrepancies.

Update Control Software:

  • Check for and install any available updates for the control software to address potential bugs or signal processing issues.

Consult Technical Support:

  • If the issue persists, contact John Deere technical support for further diagnostics and solutions.
  • Provide detailed logs of the sensor readings and any steps already taken to address the fault.

Note:

Ensuring the accuracy and proper functioning of the steering wheel position sensor is crucial for the steering system’s performance. Regular inspections and updates can help maintain system reliability.


Control Units: John Deere