BCU 523806.19 – Incorrect CAN BUS Message for Y75 Solenoid, PTO Speed 3. John Deere System Advisory.
BCU 523806.19 (BCU )
Code: 523806.19
Shortcode:
Description:
Diagnostic trouble code BCU 523806.19 is issued when there is a communication error in the CAN BUS system involving the Y75 solenoid for PTO (Power Take-Off) Speed 3. This fault occurs when the output designated for switching the solenoid is erroneously energized by more than one control unit, indicating a potential conflict or misconfiguration in the CAN BUS communication network.
Reaction:
The system may react to this error by disabling the Y75 solenoid to prevent unintended operation due to conflicting commands. A warning may be displayed to alert the operator of the issue, necessitating immediate attention to resolve the communication error.
Recommendations:
- Diagnose CAN Bus Communication: Use diagnostic tools to examine the communication paths within the CAN BUS system. Identify any misconfigurations or errors that are causing multiple control units to energize the same output.
- Reconfigure System Settings: Adjust the settings in the control units to ensure that only the correct unit sends activation signals for the Y75 solenoid. Remove any duplicate configurations or correct misassigned controls.
- Inspect and Secure Wiring Connections: Ensure that all wiring connections are correct and secure, as poor connections can sometimes mimic or cause communication errors.
- Test System Operation: After making adjustments, thoroughly test the system to ensure the Y75 solenoid operates correctly, with signals being correctly issued by the appropriate control unit without any overlaps.
- Update Software/Firmware: If necessary, update the software or firmware of the involved control units to enhance their communication protocols and prevent future issues.
Note:
Maintaining clear and precise communication in vehicle control systems is crucial for operational reliability. Regular system checks and updates of the system configurations and CAN BUS protocols are necessary to prevent communication errors and ensure that each component functions correctly as part of the overall system architecture.