This error code, TEI 600006.31, is triggered by the CommandCenter (DTI) when the DTI receives a TEI diagnostic trouble code via the CAN BUS that is not stored in the DTI memory. This “general” diagnostic trouble code enables the CommandCenter…

READ MORE

This error code, TEI 523652.02, is saved when the TEC control unit detects an erroneous signal in the circuit of the control unit identification. This usually occurs when the control unit is connected to the wrong wiring harness connector.

READ MORE

This error code, TEI 522550.14, is triggered when the implement connected to the ISOBUS does not conform to the ISO standard. This indicates that the implement is not recognized or supported by the TEI control unit due to incompatibility issues.

READ MORE

This error code, TEI 001231.14, is saved when the data received by the TEI control unit from the CAN BUS are extremely faulty or incomplete. This indicates a severe communication problem within the vehicle’s CAN BUS network.

READ MORE

This error code, TEI 001231.12, is saved when the data received by the TEI control unit from the CAN BUS are faulty or incomplete. This indicates a significant communication issue within the vehicle’s CAN BUS network.

READ MORE

This error code, TEI 000639.14, is saved when the data received by the TEI control unit from the ISOBUS are extremely faulty or incomplete. This indicates a significant communication problem within the ISOBUS network.

READ MORE

This error code, TEI 000639.12, is saved when the data received by the TEI control unit from the ISOBUS is faulty or incomplete. This indicates a communication problem within the ISOBUS network.

READ MORE

This error code, TEI 000630.02, indicates that an incorrect entry has been detected in the internal memory of the control unit. This typically signifies a data corruption or memory fault within the control unit.

READ MORE

This error code, TEI 000629.12, is triggered when an internal fault occurs in the TEC control unit. It signifies that the control unit has encountered an issue that prevents it from operating correctly.

READ MORE

This error code, TEI 000628.12, indicates that the control unit has switched to an incorrect mode, specifically boot mode. This typically happens when the control unit encounters an internal fault that prevents it from functioning correctly.

READ MORE