Description:

This error code, CSM 523343.03, indicates that the sensor voltage in the single lever control trigger circuit is too high. This can be due to a fault in the sensor, wiring issues, or a malfunctioning power supply.

Reaction:

The function of the single lever control is disabled to prevent incorrect operations due to erroneous sensor readings.

Recommendations:

Inspect Sensor:

• Examine the single lever control trigger sensor for any faults. Replace the sensor if it is found to be defective.

Check Wiring and Connections:

• Inspect the wiring and connections in the sensor circuit for signs of damage, loose connections, or corrosion. Secure and clean all connections as needed.

Measure Circuit Voltage:

• Use a multimeter to measure the voltage in the sensor circuit. Ensure that it is within the specified range. Identify and correct any sources of excessive voltage.

Evaluate Power Supply:

• Check the power supply to the sensor circuit for proper operation. Replace or repair the power supply if it is causing high voltage.

Reset and Test System:

• After resolving the issue, reset the system and perform tests to ensure the sensor voltage is within the acceptable range and the single lever control function is restored.

Note:

Maintaining the correct sensor circuit voltage is essential for accurate sensor operation. Regular checks and maintenance of the sensor, wiring, and power supply can prevent high voltage issues.