This diagnostic trouble code, RPT 524252.15, is generated when the RPT control software detects that the current at the connecting leads of the rear PTO solenoid valve is too high. This indicates a short circuit to ground.

READ MORE

This diagnostic trouble code, RPT 524252.14, is generated when the RPT control software detects that the voltage in the positive lead of the rear PTO solenoid valve is above 16 V. This indicates a short to a higher voltage source.

READ MORE

This diagnostic trouble code, RPT 524252.05, is generated when the RPT control software detects that the current in the ground lead of the rear PTO solenoid valve is too low. This indicates that the circuit is open.

READ MORE

This diagnostic trouble code, RPT 524252.04, is generated when the RPT control software detects that the voltage in the positive lead of the rear PTO solenoid valve is too low. This indicates a short circuit to ground.

READ MORE

This diagnostic trouble code, RPT 524224.31, is generated when the OIC control software detects an open circuit in the circuit of the rear PTO switch. A transmitted replacement value generates this diagnostic trouble code in the RPT control software. In its active state, this fault also generates a diagnostic trouble code at the OIC control…

READ MORE

This diagnostic trouble code, RPT 524224.19, is generated when the OIC control software cannot determine the values of the rear PTO switch and cannot provide the CAN bus with any data. A transmitted replacement value generates this diagnostic trouble code in the RPT control software. The OIC diagnostic trouble codes take priority.

READ MORE

This diagnostic trouble code, RPT 524224.09, is generated when the CAN bus message from the OIC (Operator Interface Control) control software about the rear PTO remote control switch value is not updated regularly via the CAN bus. The OIC diagnostic trouble codes take priority.

READ MORE

This diagnostic trouble code, RPT 524224.02, is generated when the messages from the OIC (Operator Interface Control) control software about the rear PTO switch value are not plausible. The OIC diagnostic trouble codes take priority.

READ MORE

This diagnostic trouble code, RPT 524218.31, is generated when the PTA (AutoPowr™/IVT™ transmission), PTQ (PowrQuad™ transmission), or PTD (DirectDrive transmission) control software detects an open circuit at the park position sensor. A transmitted replacement value generates this diagnostic trouble code in the RPT control software. In its active state, this fault also generates a diagnostic…

READ MORE

This diagnostic trouble code, RPT 524218.19, is generated when the park position signal cannot be determined and provided on the CAN bus by the control software for PTA (AutoPowr™/IVT™ transmission), PTQ (PowrQuad™ transmission), or PTD (DirectDrive transmission). A transmitted replacement value generates this diagnostic trouble code. In its active state, this fault can also generate…

READ MORE

This diagnostic trouble code, RPT 524218.09, indicates a data transfer problem between the RPT control software and PTA (AutoPowr™/IVT™ transmission), PTQ (PowrQuad™ transmission), or PTD (DirectDrive transmission) control software. This suggests an issue with the CAN bus or the transmitting control software.

READ MORE