This diagnostic trouble code, RPT 523815.01, is generated when the PAP control software measures a supply voltage of less than 3 V at the output to the solenoid for PTO speed 3 when the solenoid is turned on. This indicates a supply voltage fault or a potential issue with the solenoid circuit.

READ MORE

This diagnostic trouble code, RPT 523815.00, is generated when the PAP (Power Accessory Point) control software measures a total current above 40 A at the outputs to the solenoids for PTO speeds. This indicates a short to ground or a defective component in one of the monitored circuits.

READ MORE

This diagnostic trouble code, RPT 523814.19, is generated when the output for switching the solenoid for PTO speed 2 is energized by more than one control software. This indicates a conflict in control software communication.

READ MORE

This diagnostic trouble code, RPT 523814.12, is generated when the PAP control software measures a current of more than 1 A at the output to the solenoid for PTO speed 2 when the solenoid is turned off. This indicates a short in the circuit or an internal fault of the control software.

READ MORE

This diagnostic trouble code, RPT 523814.11, is generated when there is a circuit fault in the solenoid for PTO speed 2. This could be due to a shorted circuit, open circuit, or overheating of the solenoid.

READ MORE

This diagnostic trouble code, RPT 523814.09, is generated when there is a data transfer problem between the PAP (Power Accessory Point) control software and the RPT control software. The issue arises when the RPT control software intermittently or completely fails to receive one, several, or all of the expected CAN messages from the PAP. This…

READ MORE

This diagnostic trouble code, RPT 523814.05, is generated when the PAP control software measures a current of less than 500 mA at the output to the solenoid for PTO speed 2 when the solenoid is turned on. This indicates that the circuit is open.

READ MORE

This diagnostic trouble code, RPT 523814.04, is generated when the PAP control software measures a current above 30 A when the solenoid for PTO speed 2 is turned on. This indicates a grounded circuit.

READ MORE

This diagnostic trouble code, RPT 523814.03, is generated when the PAP (Power Accessory Point) control software detects a voltage that is too high (12 volts) at the output to the solenoid for PTO speed 2 when the solenoid is turned on. This indicates a circuit that is open or shorted to 12 volts.

READ MORE

This diagnostic trouble code, RPT 523814.01, is generated when the PAP control software measures a supply voltage of less than 2 V at the output to the solenoid for PTO speed 2 when the solenoid is turned on. This indicates a supply voltage fault or a potential issue with the solenoid circuit.

READ MORE

This diagnostic trouble code, RPT 523814.00, is generated when the PAP (Power Accessory Point) control software measures a total current above 40 A at the outputs to the solenoids for PTO speeds. This indicates a short to ground or a defective component in one of the monitored circuits.

READ MORE