This diagnostic trouble code, RPT 000186.17, is generated when the RPT control software detects that the rear PTO speed is too low. Insufficient speed can indicate a malfunction in the PTO system or improper operation of the connected implement.

READ MORE

This diagnostic trouble code, RPT 000186.15, is generated when the RPT control software detects that the rear PTO speed is too high. Excessive speed can indicate a malfunction in the PTO system or improper operation of the connected implement.

READ MORE

This diagnostic trouble code, RPT 000186.05, is generated when the RPT control software detects that the voltage at the output to the rear PTO speed sensor is too high, indicating an open circuit. An open circuit means that there is a break or disconnection in the electrical pathway, preventing the sensor from functioning correctly.

READ MORE

This diagnostic trouble code, RPT 000186.04, is generated when the control software detects that the voltage at the signal input of the rear PTO speed sensor is too low. This indicates a short to ground in the circuit of the rear PTO speed sensor.

READ MORE

This diagnostic trouble code, RPT 000186.01, is generated when the rear PTO does not start up correctly after being turned on. The rear PTO is turned off and can only be turned back on again after 30 seconds. This indicates that the rear PTO is overloaded, possibly due to an implement being blocked or sluggish,…

READ MORE

This diagnostic trouble code, RPT 000177.31, is triggered when the PTA or CCU control software detects an open circuit to the transmission oil temperature sensor. A transmitted replacement value generates this diagnostic trouble code in the RPT control software. When active, this fault also generates a diagnostic trouble code in the PTA or CCU control…

READ MORE

This diagnostic trouble code, RPT 000177.19, is generated when the PTA or CCU control software cannot determine the temperature of the transmission oil and, therefore, cannot provide the CAN bus with any relevant data. This results in a transmitted replacement value, triggering the diagnostic trouble code in the RPT control software. When active, this fault…

READ MORE

This diagnostic trouble code, RPT 000177.09, is generated when there is a data transfer problem between the RPT control software and the PTA or PTD control software. The issue arises when the RPT control software intermittently or completely fails to receive one, several, or all of the expected CAN messages. This problem is indicative of…

READ MORE

This diagnostic trouble code, RPT 000168.04, is triggered when the supply voltage (BAT) to the control software drops below 9 volts. Low voltage levels can lead to malfunctioning of the control software and affect the overall performance of the equipment.

READ MORE

This diagnostic trouble code, RPT 000168.03, is triggered when the supply voltage (BAT) to the control software exceeds 16 volts. Such high voltage levels can lead to malfunctioning of the control software and affect the overall performance of the equipment.

READ MORE

This diagnostic trouble code, RPT 000158.04, is triggered when the supply voltage (ELX) to the control software drops below 9 volts. Low voltage levels can lead to malfunctioning of the control software and affect the overall performance of the equipment.

READ MORE