This diagnostic trouble code is generated if the control software detects that the second attempt to engage the range has failed. In its active state, this fault also generates the diagnostic trouble code for time-out when engaging the gear. The operator is prompted to engage the range again.

READ MORE

This diagnostic trouble code is generated if the control software detects that it takes too long to engage the range. The control software automatically attempts a second engagement.

READ MORE

This diagnostic trouble code is generated if the control software detects that after several attempts, the range cannot be engaged. This indicates a mechanical problem with the transmission. The range is disabled until the next tractor start-up.

READ MORE

This diagnostic trouble code is generated if the control software detects that the current value at the Range B solenoid is too high. This may indicate a shorted circuit.

READ MORE

This diagnostic trouble code is generated if the control software detects that the current value at the Range B solenoid is too low. This may indicate an open circuit.

READ MORE

This diagnostic trouble code is generated if the control software detects that the second attempt to engage the range has failed. In its active state, this fault also generates the diagnostic trouble code for time-out when engaging the gear. The operator is prompted to engage the range again.

READ MORE

This diagnostic trouble code is generated if the control software detects that it takes too long to engage the range. The control software automatically attempts a second engagement.

READ MORE

This diagnostic trouble code is generated if the control software detects that after several attempts, the range cannot be engaged. This indicates a mechanical problem with the transmission. The range is disabled until the next tractor start-up.

READ MORE

This error code, RPM 521926.06, is generated if the control software detects that the current value at the Range C solenoid is too high. This may indicate a shorted circuit.

READ MORE

This error code, RPM 521926.05, is generated if the control software detects that the current value at the Range C solenoid is too low. This may indicate an open circuit.

READ MORE

This error code, RPM 521991.12, is generated if the control software detects that the temperature of the control unit for gear shifting is too high. This may occur if an extremely high number of shifts are performed in a short period of time.

READ MORE