This diagnostic trouble code is generated when the direction of travel does not match the commanded direction of travel, indicating a failed shift operation.

READ MORE

This diagnostic trouble code is generated to inform the operator that the transmission warm-up routine is active due to the transmission oil temperature being below -15°C (5°F). During this routine, all clutches, gears, and ranges of the transmission are automatically shifted to warm up the oil. Operator commands are ignored until the warm-up routine is…

READ MORE

This diagnostic trouble code is generated when the control software detects that the reverse drive lever position does not match the desired direction of travel from the TID control software.

READ MORE

This diagnostic trouble code is generated when the control software expects but does not receive the wheel speed signal from channel 1. This code can also be generated if there is a difference of more than 10 km/h (6.2 mph) compared to the wheel speed sensor on channel 2.

READ MORE

This diagnostic trouble code is generated when the control software detects a fault in the forward clutch oil pressure sensor.

READ MORE

This diagnostic trouble code is generated when the control software detects that the voltage at the lead of the forward clutch oil pressure sensor is too low, indicating an open circuit.

READ MORE

This diagnostic trouble code is generated when the control software detects that the voltage at the lead of the forward clutch oil pressure sensor is too high, indicating a short circuit.

READ MORE

This diagnostic trouble code is generated when the control software detects a fault in the reverse brake oil pressure sensor.

READ MORE

This diagnostic trouble code is generated when the control software detects that the voltage at the lead of the reverse brake oil pressure sensor is too low, indicating an open circuit.

READ MORE

This diagnostic trouble code is generated when the control software detects that the voltage at the lead of the reverse brake oil pressure sensor is too high, indicating a short circuit.

READ MORE

This diagnostic trouble code is generated when there is no oil pressure at the reverse brake even though an oil pressure was specified. This indicates a problem in the oil circuit of the reverse brake or a faulty proportional solenoid valve.

READ MORE