This diagnostic trouble code is generated when the TIA control software is unable to determine the desired transmission ratio (DTRR) and cannot provide the CAN Bus with relevant data. A transmitted replacement value generates this diagnostic trouble code in the PTA control software.

READ MORE

This diagnostic trouble code is generated when the TIA control software is unable to determine the clutch torque command (DCTL) and cannot provide the CAN BUS with relevant data. A transmitted replacement value generates this diagnostic trouble code in the PTA control software.

READ MORE

This diagnostic trouble code is generated when the TIA control software is unable to determine the desired acceleration value (DTOA) and cannot provide the CAN BUS with relevant data. A transmitted replacement value generates this diagnostic trouble code in the PTA control software.

READ MORE

This diagnostic trouble code is generated when the main control software does not match the control unit, indicating an incorrect software configuration.

READ MORE

This diagnostic trouble code is generated when the amperage at the proportional solenoids of the hydrostatic unit does not match the registered ratio between the transmission input speed and the speed of the hydrostatic unit, indicating a problem with the hydrostatic unit.

READ MORE

This diagnostic trouble code is generated when the PTA control software registers a current value at the proportional solenoid valve for the reverse clutch that does not correspond with the switch status of the reverse clutch, indicating that the circuit of the solenoid valve is open.

READ MORE

This diagnostic trouble code is generated when the PTA control software registers a voltage value at the proportional solenoid valve for the reverse clutch that does not correspond with the switch status of the reverse clutch, indicating a short to ground in the circuit.

READ MORE

This diagnostic trouble code is generated when the PTA control software registers a voltage value at the proportional solenoid valve for the reverse clutch that does not correspond with the switch status of the reverse clutch. This indicates a short to a positive lead or a defective proportional solenoid valve.

READ MORE

This diagnostic trouble code is generated when the PTA control software registers a current value at the proportional solenoid valve for the forward clutch that does not correspond with the switch status of the forward clutch, indicating that the circuit of the solenoid valve is open.

READ MORE

This diagnostic trouble code is generated when the PTA control software registers a voltage value at the proportional solenoid valve for the forward clutch that does not correspond with the switch status of the forward clutch, indicating a short to ground in the circuit.

READ MORE

This diagnostic trouble code is generated when the PTA control software registers a voltage value at the proportional solenoid valve for the forward clutch that does not correspond with the switch status of the forward clutch. This indicates a short to a positive lead or a defective proportional solenoid valve.

READ MORE