This diagnostic trouble code is generated when the PTA control software detects that the current in the ground lead of the park lock solenoid valve 1 is too low, indicating that the circuit is open.

READ MORE

This diagnostic trouble code is generated when the PTA control software detects that the voltage in the positive lead of the park lock solenoid valve 1 is too low, indicating a short circuit to ground.

READ MORE

This diagnostic trouble code is generated when the PTA control software detects that the voltage in the positive lead of the park lock solenoid valve 1 is above 12V, indicating a short to a supply lead.

READ MORE

This diagnostic trouble code is generated when the PTA control software detects a false setting or input in the tractor model address, indicating incorrect configuration of the control software.

READ MORE

This diagnostic trouble code is generated when the PTA control software detects a faulty 5-volt supply voltage to the lube oil pressure sensor, indicating a short circuit to ground.

READ MORE

This diagnostic trouble code is generated when there is a data transfer problem between the PTA control software and the PLC control software. Intermittent or non-existent reception of messages sent on the CAN BUS by the PLC control software indicates an open circuit, a short circuit, or faulty CAN BUS terminating resistors.

READ MORE

This diagnostic trouble code is generated when there is a data transfer problem between the PTA control software and the TIA control software. Intermittent or non-existent reception of messages sent on the CAN BUS by the TIA control software indicates an open circuit, a short circuit, or faulty CAN BUS terminating resistors.

READ MORE

This diagnostic trouble code is generated when there is a data transfer problem between the ECU control software and the PTA control software. Intermittent or non-existent reception of messages sent on the CAN BUS by the ECU control software indicates an open circuit, a short circuit, or faulty CAN BUS terminating resistors.

READ MORE

This diagnostic trouble code is generated when the PTA control software detects that the voltage at the lube oil pressure sensor is too low, indicating a short to ground in the sensor circuit.

READ MORE

This diagnostic trouble code is generated when the PTA control software detects that the voltage at the lube oil pressure sensor is too high. This indicates that the sensor circuit is open or shorted to a positive lead in the sensor circuit.

READ MORE

This diagnostic trouble code is generated when the PTA control software is unable to determine transmission lube oil pressure, indicating that the oil pressure is too low.

READ MORE