Description: This error code is triggered when there is a data transfer problem between the PL4 control software and the PL1 control software. The reception of messages sent on the CAN Bus by the PL1 control software is intermittent or non-existent. This typically indicates an open circuit in the CAN Bus, a short circuit, or…

READ MORE

This code indicates that the tractor is in come-home mode, with the connector in the COME HOME position. The operator must release the clutch pedal to proceed to the next stage of the come-home function.

READ MORE

This code indicates that the tractor is in come-home mode, with the connector in the COME HOME position. The operator must fully actuate the clutch pedal to proceed to the next stage of the come-home function.

READ MORE

This code indicates that the tractor is in come-home mode, with the connector in the COME HOME position. The operator must actuate the clutch to stop the tractor.

READ MORE

This diagnostic trouble code is generated when the control software detects that the voltage at the lead of the clutch pedal potentiometer is too low. This typically indicates an open circuit in the potentiometer circuit.

READ MORE

This diagnostic trouble code is generated when the control software detects that the voltage at the lead of the clutch pedal potentiometer is too high. This typically indicates a short circuit in the potentiometer circuit.

READ MORE

This diagnostic trouble code is generated when the control software detects a position fault with the clutch pedal potentiometer. This may indicate issues with the potentiometer sensor, wiring, or mechanical linkage.

READ MORE

This code indicates that the tractor is in come-home mode, with the connector in the COME HOME position. The operator needs to move the reverse drive lever to the neutral or park position to proceed to the next stage of the come-home function.

READ MORE

This code indicates that the tractor is in come-home mode, with the connector in the COME HOME position. The operator needs to select a direction of travel to proceed to the next stage of the come-home function.

READ MORE

This diagnostic trouble code is generated when the PL3 control software detects a ground speed of more than 0.1 km/h (0.06 mph) for longer than 0.7 seconds after engaging the park lock. This indicates that the vehicle is moving despite the park lock being engaged.

READ MORE

This diagnostic trouble code is generated when the control software detects an error reading the internal module (EEPROM). This could be due to software corruption, hardware failure, or other internal issues.

READ MORE