This diagnostic trouble code is generated when the control unit for range shifting (DirectDrive transmission) detects a current that is too high at the driver output. The driver outputs at the control unit are switched off to prevent damage.

READ MORE

This diagnostic trouble code is generated when there is a data transfer problem between the PL3 control software and the PL2 control software. The reception of messages sent on the CAN Bus by the PL2 control software is intermittent or non-existent, indicating an open circuit in the CAN Bus, a short circuit, or faulty CAN…

READ MORE

This diagnostic trouble code is generated when there is a data transfer problem between the PL3 control software and the PL1 control software. The reception of messages sent on the CAN Bus by the PL1 control software is intermittent or non-existent, indicating an open circuit in the CAN Bus, a short circuit, or faulty CAN…

READ MORE

This diagnostic trouble code is generated when the control software detects too many incorrect CAN Bus messages at a rate of 1000 kBd, indicating a general problem with the Drive Train CAN Bus connection.

READ MORE

This diagnostic trouble code is generated when the control software is unable to process all CAN Bus messages received at a rate of 1000 kBd, indicating a high error rate. This can be due to a CAN Bus overload or an internal control unit fault.

READ MORE

This diagnostic trouble code is generated when the control software detects too many incorrect CAN Bus messages at a rate of 500 kBd, indicating a general problem with the Vehicle CAN Bus connection.

READ MORE

This diagnostic trouble code is generated when the control software is unable to process all CAN Bus messages received at a rate of 500 kBd, indicating a high error rate. This can be due to a CAN Bus overload or an internal control unit fault.

READ MORE

This diagnostic trouble code is generated when the control software detects that the internal memory contains an incorrect entry, indicating that the driver is not calibrated correctly.

READ MORE

This diagnostic trouble code is generated when an internal error occurs during the launch of the control software. This could be due to software bugs, corrupted data, or hardware issues.

READ MORE

This diagnostic trouble code is generated when a fault occurs during the software launch, often due to watchdog timer issues. This indicates that the control software encountered a problem during its initialization.

READ MORE

This diagnostic trouble code is generated when an electronic fault is detected within the control software. This could be due to software corruption, hardware failures, or other internal issues.

READ MORE