This diagnostic trouble code is generated if the control software detects that the temperature of the control unit for gear shifting is too high. This may occur if an extremely high number of shifts are performed in a short period of time.

READ MORE

This diagnostic trouble code is generated if the control software detects that the overall current strength of the solenoid coils is too high. The control unit enters a cooling phase, making gear shifting impossible until 30 seconds have elapsed.

READ MORE

This code informs the operator that Range A has disengaged unexpectedly. The operator needs to re-engage Range A.

READ MORE

This code informs the operator that the second attempt to engage Gear 4 has failed. In its active state, this fault also generates the diagnostic trouble code for time-out when engaging the gear. The operator needs to attempt to engage Gear 4 again.

READ MORE

This diagnostic trouble code is generated if the control software detects that it takes too long to engage Gear 4. The system will automatically attempt to engage the gear a second time.

READ MORE

This code informs the operator that Gear 4 has disengaged unexpectedly. The operator needs to re-engage Gear 4.

READ MORE

This diagnostic trouble code is generated if the control software detects that after several attempts, Gear 4 cannot be engaged. This indicates a mechanical problem with the gear. The gear is disabled until the next tractor start-up.

READ MORE

This diagnostic trouble code is generated if the control software detects that the current value at the solenoid for Gear 4 is too high. This condition typically indicates a short circuit, which could be due to wiring issues, a faulty solenoid, or connector problems.

READ MORE

This diagnostic trouble code is generated if the control software detects that the current value at the solenoid for Gear 4 is too low. This condition typically indicates an open circuit, which could be due to wiring issues, a faulty solenoid, or connector problems.

READ MORE

This code informs the operator that the second attempt to engage Gear 5 has failed. In its active state, this fault also generates the diagnostic trouble code for time-out when engaging the gear. The operator needs to attempt to engage Gear 5 again.

READ MORE

This diagnostic trouble code is generated if the control software detects that it takes too long to engage Gear 5. The system will automatically attempt to engage the gear a second time.

READ MORE