This error code, XSC 523137.14, indicates a fault in the steering system. It is essential to address other diagnostic trouble codes first before resolving this issue, as it may be related to other underlying problems.

READ MORE

This error code, XSC 522976.12, indicates an identification problem with the control software. This issue may occur if the control software is connected to the wrong wiring harness or if it has been programmed incorrectly.

READ MORE

This error code, XSC 522920.09, indicates a data transfer problem between the XMC control software and the XSC control software. This issue could be due to problems in the CAN Bus network or the transmitting control software, affecting the communication necessary for proper system operation.

READ MORE

This error code, XSC 522777.05, indicates that the voltage at the output to the steering wheel position sensor is too high, suggesting that the circuit is open.

READ MORE

This error code, XSC 522777.02, indicates that the values of the steering wheel position sensor channels 1 and 2 differ by more than 5 percent. This discrepancy suggests a problem with the steering wheel position sensor.

READ MORE

This error code, XSC 522768.05, indicates that the XSC control software detects an open ground circuit at pin J2L3. This open ground can lead to improper functioning or complete failure of the control software.

READ MORE

This error code, XSC 522767.05, indicates that the XSC control software detects an open ground circuit at pin J2L4. This open ground can result in improper functioning or complete failure of the control software.

READ MORE

This error code, XSC 522451.02, indicates that the signal voltage ratio between the two separate sensors in the wheel angle sensor (WAS) is incorrect. Sensor 2’s signal voltage should be half of Sensor 1’s, but a difference of 0.4 volts or more has been detected.

READ MORE

This error code, XSC 522451.01, indicates that the voltage at channel 2 of the wheel angle sensor is below 0.25 volts. This low voltage suggests a potential issue with the sensor or signal processing, which can disrupt normal operation.

READ MORE

This error code, XSC 522451.00, indicates that the voltage at channel 2 of the wheel angle sensor exceeds 2.25 volts. This high voltage suggests a potential issue with the sensor or signal processing, which can disrupt normal operation.

READ MORE

This error code, XSC 522390.19, is generated when no valid information from the implement is received via the implement CAN Bus. This indicates a potential problem in the CAN Bus network or the implement control software, affecting the data communication necessary for Tractor-Implement Automation™.

READ MORE