This diagnostic trouble code, TSC 000628.12, is triggered when an electronic malfunction is registered in the control unit, causing it to fail to boot. This fault may also occur during the reprogramming of the TSC (Tractor Steering Controller).

READ MORE

This diagnostic trouble code, TSC 000597.19, is triggered when the BCU (Brake Control Unit) transmits incorrect sensor status signals on the CAN BUS. These signals indicate either: The brake pedal sensor is not available. The sensor signal is faulty, possibly due to a circuit problem at the brake pedal sensor unit.

READ MORE

This diagnostic trouble code, TSC 000190.31, is triggered when the ECU transmits an engine speed between 100 and 500 rpm for longer than 5 seconds while the tractor is in motion. This can occur due to a sudden drop in engine speed or if the ECU sends incorrect engine speed data while the tractor is…

READ MORE

This diagnostic trouble code, TSC 000190.19, is triggered when the ECU transmits an engine speed between 100 and 500 rpm for longer than 5 seconds while the tractor is stationary. This can occur if the engine speed drops suddenly or if the ECU sends incorrect engine speed data while the tractor is not in motion.

READ MORE

This diagnostic trouble code, TSC 000190.17, is triggered when the ECU transmits an engine speed between 100 and 500 rpm for longer than 5 seconds. This can occur due to a sudden drop in engine speed or if the ECU sends incorrect engine speed data.

READ MORE

This diagnostic trouble code, TSC 000168.04, is triggered when the control unit detects a supply voltage (battery) below 9 volts. Low supply voltage can be caused by a weak battery, poor electrical connections, or a malfunctioning charging system.

READ MORE

This diagnostic trouble code, TSC 000168.03, is triggered when the control unit detects a supply voltage (battery) exceeding 16 volts. High supply voltage can occur due to issues with the charging system or battery.

READ MORE

This diagnostic trouble code, TSC 000084.19, is triggered when the BCU (Brake Control Unit) transmits incorrect sensor status signals on the CAN BUS. These signals indicate either: The wheel speed sensor is not available, likely due to incorrect configuration. The sensor signal is faulty, possibly due to a circuit problem at the wheel speed sensor.

READ MORE

This diagnostic trouble code, TSC 000084.15, is triggered when the TSC control unit detects a wheel speed above 0.5 km/h (0.3 mph) via CAN BUS during calibration of the cab suspension or TLS. Potential causes include: Defective wheel speed sensor B09/B35 (for PowrQuad transmission) or transmission output speed sensor B63 (for AutoPowr/IVT transmission). Incorrect wheel…

READ MORE