This error code, SIC 523819.09, is generated when there is a problem in transmitting data between the stepper motor of ESCV 2 (Electro-Hydraulic Section Control Valve) and the control unit. Following a successful initialization (link made after ignition ON), the control unit fails to establish a connection to the stepper motor, or makes only intermittent…

READ MORE

This error code, SIC 523818.14, is saved when there is a problem in transmitting data between the stepper motor of ESCV 3 and the control unit. Intermittently, the stepper motor cannot establish any connection to the control unit via the CAN BUS for ESCV/EICV. The stepper motor itself is not responsible for this diagnostic trouble…

READ MORE

This error code, SIC 523818.09, is generated when there is a problem in transmitting data between the stepper motor of ESCV 3 (Electro-Hydraulic Section Control Valve) and the control unit. Following a successful initialization (link made after ignition ON), the control unit fails to establish a connection to the stepper motor, or makes only intermittent…

READ MORE

This error code, SIC 523817.14, is saved when there is a problem in transmitting data between the stepper motor of ESCV 4 and the control unit. Intermittently, the stepper motor cannot establish any connection to the control unit via the CAN BUS for ESCV/EICV. The stepper motor itself is not responsible for this diagnostic trouble…

READ MORE

This error code, SIC 523817.09, is generated when there is a problem in transmitting data between the stepper motor of ESCV 4 (Electro-Hydraulic Section Control Valve) and the control unit. Following a successful initialization (link made after ignition ON), the control unit fails to establish a connection to the stepper motor, or makes only intermittent…

READ MORE

This error code, SIC 523816.07, is generated when the control unit detects incorrect signals from the activation switch for the EICVs (Electro-Hydraulic Integrated Control Valves) on the S64 MultiFunction Lever. This indicates a potential fault in the activation switch or related circuitry.

READ MORE

This error code, SIC 523794.19, is triggered when the outputs for switching the ESCV stepper motors are energized by more than one control unit. This indicates a conflict in control signals being sent to the ESCV stepper motors.

READ MORE

This error code, SIC 523794.12, is generated when the power module PC5 measures a current of more than 1 amp at the power supply output to the ESCV (Electro-Hydraulic Section Control Valve) stepper motors (lead 7031) with the multifunction lever not actuated. This indicates a short in the circuit or an internal fault in the…

READ MORE

This error code, SIC 523794.11, is triggered when a fault occurs within the internal module of the control unit. This indicates potential issues with internal components or processes within the control unit.

READ MORE

This error code, SIC 523794.09, is generated when there is a problem transferring data between the SIC control unit and the power module PC5. The reception of one, several, or all of the CAN messages transmitted by the SIC to the power module PC5 is intermittent or nonexistent, which could be due to a loose…

READ MORE

This error code, SIC 523794.05, is generated when the power module PC5 does not measure current at the power output to the ESCV (Electro-Hydraulic Section Control Valve) stepper motors. This indicates that the circuit is open or there is a defective component in the circuit.

READ MORE