This error code, SIC 523790.01, is generated when the power module PC5 registers a supply voltage of less than 3 volts at the EICV (Electro-Hydraulic Integrated Control Valve) stepper motor outputs when switching on the EICV stepper motors (M12, M14).

READ MORE

This error code, SIC 523790.00, is triggered when power module PC5 measures more than 20 amps at the power output to the EICV (Electro-Hydraulic Integrated Control Valve) stepper motors. This indicates that the circuit is shorted to ground or there is a defective component in the circuit.

READ MORE

This error code, SIC 523652.02, is triggered when an internal fault occurs within the SIC control unit. The fault indicates general issues that may affect the overall functionality and reliability of the control unit.

READ MORE

This error code, SIC 523438.02, is triggered when a fault occurs in the internal module, specifically the EEPROM (Electrically Erasable Programmable Read-Only Memory). This fault indicates issues related to data storage and retrieval within the control unit.

READ MORE

This error code, SIC 003598.04, is generated when the voltage for functions 4 and 5 of the S64 MultiFunction Lever is too low. The relay of these SIC functions is powered by a SIC output (pin 2K1, lead 7088). This indicates a potential short to ground.

READ MORE

This error code, SIC 002246.09, is generated when there is a data transfer problem between the Diagnostic System Module (DSM) and the SIC control unit. The reception of one, several, or all CAN messages transmitted by the DSM is intermittent or nonexistent, which could be due to a loose wire or other communication issues.

READ MORE

This error code, SIC 002155.09, is generated when there is a problem transferring data between the power module PC5 and the SIC control unit. The reception of one, several, or all CAN messages transmitted by the power module PC5 is intermittent or nonexistent, which could be due to a loose wire or other communication issues.

READ MORE

This error code, SIC 002033.09, is generated when there is a data transfer problem between the Body Control Unit (BCU) and the SIC control unit. This issue indicates that the messages required for the operation of the ESCV (Electro-Hydraulic Section Control Valve) / EICV (Electro-Hydraulic Integrated Control Valve) control unit are intermittent or nonexistent, which…

READ MORE

This error code, SIC 002003.09, is generated when there is a data transfer problem between the Electronic Power Control (EPC) or Transmission Control Unit (TCU) and the SIC control unit. This issue indicates that the messages received via the CAN BUS are incorrect or corrupted.

READ MORE

This error code, SIC 002000.09, is generated when there is a data transfer problem between the Engine Control Unit (ECU) and the SIC control unit. This issue indicates that the messages received via the CAN BUS are incorrect or corrupted.

READ MORE

This error code, SIC 001079.04, is saved when the power supply for the 5-volt components (such as potentiometers for control levers and multifunction lever, and the ESCV adjusting knob) is detected to be too low. This can indicate a malfunction in the voltage regulation system or a potential power supply issue.

READ MORE