This error code indicates that the calibration range of the front axle left position sensor is below 1.5 Volts. This can be caused by incorrect calibration procedures, a faulty sensor, or wiring issues.

READ MORE

This error code indicates that the suspension lower control valve circuit is experiencing high current. This can be caused by a short to battery voltage on either the high or low side of the drive circuit.

READ MORE

This error code indicates that the suspension lower control valve circuit is experiencing low current. This can be caused by an open circuit or a short to ground on either the high or low side of the drive circuit.

READ MORE

This error code indicates that the suspension raise valve circuit is experiencing high current. This can be caused by a short to battery voltage on either the high or low side of the drive circuit.

READ MORE

This error code indicates that the suspension raise valve circuit is experiencing low current. This can be caused by an open circuit or a short to ground on either the high or low side of the drive circuit.

READ MORE

This error code indicates that the memory of the suspended front axle (SFA) control unit is corrupted. This can occur due to software bugs, power surges, or other internal faults.

READ MORE

This error code indicates that the front axle is not responding to the lower command. The position sensor detects no downward movement for longer than 10 seconds, which may be caused by mechanical obstructions, faulty sensors, or issues within the hydraulic system.

READ MORE

This error code indicates that the suspension system is not responding to the raise command. The position sensor detects no upward movement for longer than 10 seconds, which may be caused by mechanical obstructions, faulty sensors, or issues within the hydraulic system.

READ MORE

This error code indicates that the control unit is connected to the wrong harness, or there is a fault with the wire connector. This can occur due to incorrect installation or wiring errors.

READ MORE

This error code indicates that the memory of the suspended front axle (SFA) control unit has become corrupted. This can occur due to software bugs, power surges, or other internal faults.

READ MORE

This error code indicates that the voltage of the right front axle position sensor is less than 0.5 Volts. This can be caused by a faulty sensor, wiring issues, or problems within the control unit.

READ MORE