This error code indicates that the right front axle position sensor voltage is greater than 4.5 Volts. This can be caused by a malfunctioning sensor, wiring issues, or faults within the control unit.

READ MORE

This error code indicates that the front axle right position sensor calibration range is below 1.5 Volts. This may be caused by incorrect calibration procedures, a faulty sensor, or wiring issues.

READ MORE

This error code indicates that the front axle locking solenoid circuit is experiencing high current, caused by a short to battery voltage on either the high or low side of the drive circuit.

READ MORE

This error code indicates that the front axle locking solenoid circuit is experiencing low current. This can be caused by an open circuit or a short to ground on either the high or low side of the drive circuit.

READ MORE

This error code indicates that the front axle unlocking solenoid circuit is experiencing high current. This can be caused by a short to battery voltage on either the high or low side of the drive circuit.

READ MORE

This error code indicates that the front axle unlocking solenoid circuit is experiencing low current. This can be caused by an open circuit or a short to ground on either the high or low side of the drive circuit.

READ MORE

This error code indicates that the Chassis Control Unit (CCU) has detected that the clean oil reservoir is low and is sending this message to the suspended front axle (SFA) control unit. This can be caused by leaks, inadequate oil levels, or issues with the oil level sensor.

READ MORE

This error code indicates that the suspended front axle (SFA) control unit is not receiving the required messages from the Chassis Control Unit (CCU). This can occur due to communication issues, wiring problems, or faults within the CCU.

READ MORE

This error code indicates that the suspended front axle (SFA) control unit is not receiving the required messages from the Cab Control Unit (CAB). This can occur due to communication issues, wiring problems, or faults within the CAB control unit.

READ MORE

This error code indicates that the suspended front axle (SFA) control unit is not receiving the required messages from the Armrest Control Unit (ACU). This can be due to communication issues, wiring problems, or faults within the ACU.

READ MORE

This error code indicates that the suspended front axle (SFA) control unit is not receiving the required messages from the AutoPowr™/IVT™ (PTI) or PowerShift (PTP) control unit. This can occur due to communication issues, wiring problems, or faults within either control unit.

READ MORE