Description:

This error code indicates that the suspended front axle (SFA) control unit has detected that the suspension system is not calibrated. This can occur after maintenance, software updates, or replacement of components without following proper calibration procedures.

Reaction:

When this error code is triggered, the suspension system may not operate correctly, potentially leading to poor ride quality, reduced handling, and unsafe driving conditions.

Recommendations:

• Perform Calibration:
  • Calibrate the suspension system following the manufacturer’s recommended procedure. Ensure that all calibration steps are completed accurately.
• Verify Calibration Procedure:
  • Double-check that the correct calibration procedure is being used for the specific model and configuration of the equipment.
• Update Software:
  • Ensure that the control unit firmware is updated to the latest version. Update the software if necessary to correct any issues affecting the calibration process.
• Inspect for Faults:
  • Check for any other fault codes that might be affecting the calibration process. Resolve any underlying issues before attempting to calibrate again.
• Consult Technical Support:
  • If calibration issues persist, consult technical support or the manufacturer for further assistance.

Note:

Proper calibration of the suspension system is essential for maintaining vehicle stability and performance. Always follow the manufacturer’s guidelines for calibration and maintenance.