This error code indicates that the frequency at channel 2 of the steering wheel position sensor has exceeded 300 Hz. While the value measured by the XSC control software is within the acceptable range, this high frequency suggests a potential issue with the sensor or its signal processing.

READ MORE

This error code indicates that a speed of over 400 rpm has been registered at channel 2 of the steering wheel position sensor. While the value measured by the XSC control software is within the acceptable range, this anomaly suggests a potential issue with the sensor or its readings.

READ MORE

This error code indicates that the duty cycle at channel 1 of the steering wheel position sensor is less than 1%. Although the value measured by the XSC control software is within the acceptable range, such a low duty cycle may suggest an issue with the sensor or its signal processing.

READ MORE

This error code indicates that the duty cycle at channel 1 of the steering wheel position sensor is greater than 99%. While the value measured by the XSC control software is within the acceptable range, such a high duty cycle may suggest an issue with the sensor or its signal processing.

READ MORE

This error code indicates that the frequency at channel 1 of the steering wheel position sensor has fallen below 150 Hz. Although the XSC control software measures this value within the acceptable range, such a low frequency may point to issues with the sensor or its signal processing.

READ MORE

This error code indicates that the frequency at channel 1 of the steering wheel position sensor has exceeded 300 Hz. While the value measured by the XSC control software is within the acceptable range, this high frequency suggests a potential issue with the sensor or its signal processing.

READ MORE

This error code indicates that a speed of over 400 rpm has been registered at channel 1 of the steering wheel position sensor. While the value measured by the XSC control software is within the acceptable range, this anomaly suggests a potential issue with the sensor or its readings.

READ MORE

This error code indicates that the control software has failed to perform the self-test. This could be due to corrupted software, hardware issues, or other internal faults preventing the system from verifying its operational status.

READ MORE

This error code indicates that the Steering Control Unit (AutoTrac™) is connected to an incompatible harness. Using the wrong harness can lead to improper functioning or complete failure of the AutoTrac™ system.

READ MORE

This error code indicates that too many incorrect CAN Bus messages are being received, suggesting a general problem at the connection to the Vehicle CAN Bus (500 kBd). Such a high error rate can severely disrupt communication within the vehicle’s network.

READ MORE

This error code indicates that the control software is unable to process all CAN Bus messages received due to a high error rate. This could be caused by a CAN Bus overload or an internal fault within the control software, leading to communication issues within the vehicle’s network.

READ MORE