This error code is generated when the vehicle detects no motion when motion is expected, while the engine is running. This indicates a potential issue with the transmission or drive system.

READ MORE

This error code is triggered when the park brake pressure drops below 1305 kPa (13 bar) (190 psi) while the park brake is commanded off. This indicates a potential issue with the park brake system not maintaining adequate pressure.

READ MORE

This error code is triggered when the park brake pressure exceeds 1305 kPa (13 bar) (190 psi) while the park brake is commanded on. This indicates a potential issue with the park brake system maintaining excessive pressure.

READ MORE

This error code is triggered when the park brake pressure sensor circuit voltage is below the valid range, indicating a potential issue with the sensor or its circuit.

READ MORE

This error code is set when the shift lever is returned to park, the sump block solenoid is commanded ON, and the PTP checks that the park brake circuit can hold pressure. If the park brake circuit fails to hold pressure during this self-check, the code is triggered. This issue may be caused by a…

READ MORE

This error code is generated when the PTP control unit detects that the current in the Park Sump Block Solenoid circuit is low. This can indicate an issue with the solenoid or its circuit.

READ MORE

This error code is stored when the tractor is started up in gear instead of in neutral. It serves as an informational warning to the operator.

READ MORE

This error code is triggered when an attempt is made to shift from NEUTRAL to gear while the operator is not seated. This is a safety feature to ensure that the operator is present during gear shifts.

READ MORE

This error code is caused by a conflict between the gear command message, park signal, not neutral signal, and transmission enable low signal. This indicates a possible issue with the speed control lever sensor circuit.

READ MORE

This error code is generated when the PTP control unit does not receive CAN messages from the SFA (Suspension Front Axle). This indicates a communication issue between the PTP and the SFA.

READ MORE