This error code indicates that the supply voltage to the control software has dropped below 9 volts. Such low voltage levels can cause the control software to operate improperly or fail to function.

READ MORE

This error code indicates that the supply voltage to the control software has risen above 18 volts. Such high voltage levels can disrupt the normal operation of the control software, potentially causing malfunction or damage.

READ MORE

This error code indicates that the switched supply voltage to the control software (ELX) has dropped below 9 volts. Low voltage can cause the control software to operate improperly or fail to function.

READ MORE

This error code indicates that the switched supply voltage to the control software (ELX) has risen above 18 volts. Excessively high voltage can disrupt the normal operation of the control software, potentially causing malfunction or damage.

READ MORE

This error code indicates that the signal from the accelerator pedal potentiometer is out of the valid range. The control system cannot properly interpret the signal, and operators are advised to use the hand throttle instead and rectify the fault.

READ MORE

This error code indicates that the voltage at the signal input of channel 1 of the accelerator pedal potentiometer is less than 0.5 volts. This low voltage suggests a problem with the signal lead or the potentiometer’s supply voltage.

READ MORE

This error code indicates that the voltage at the signal input of channel 1 of the accelerator pedal potentiometer exceeds 4.5 volts. This high voltage suggests a problem with the signal lead or the ground connection of the potentiometer.

READ MORE

This error code indicates a mismatch between the output signals of the accelerator pedal potentiometer. Specifically, the voltage at channel 1 must be double the voltage of channel 2. When this ratio is incorrect, the control system detects an anomaly in the potentiometer signals.

READ MORE