This error code, XSC 523821.02, indicates that the control unit is connected to an incorrect harness, which is incompatible with the steering control unit (AutoTrac™). This misconnection can lead to communication failures and improper operation of the steering system.

READ MORE

This error code, XSC 523815.06, is generated when the current for the steering control valve (enable valve) is too high, indicating a short to ground. Excessive current can damage the valve and disrupt the steering control system.

READ MORE

This error code, XSC 523815.05, is generated when the current for the steering control valve (enable valve) is too low, indicating that the circuit is open. This low current can affect the proper functioning of the valve and the steering control system.

READ MORE

This error code, XSC 523815.04, is generated when the voltage for the steering control valve (enable valve) is too low, indicating a short to ground. This low voltage can affect the proper functioning of the valve and the steering control system.

READ MORE

This error code, XSC 523815.03, is generated when the voltage for the steering control valve (enable valve) is too high, indicating a short to 12 volts. This high voltage can affect the proper functioning of the valve and the steering control system.

READ MORE

This error code, XSC 523795.13, indicates that the steering control valve has an invalid calibration or is not yet calibrated. Proper calibration is necessary for the accurate and effective operation of the steering control system.

READ MORE

This error code, XSC 523795.07, indicates that the steering control valve (enable valve) is sticking in its open position. This malfunction can lead to unresponsive or erratic steering control.

READ MORE

This error code, XSC 523789.13, indicates that the steering angle sensor has an invalid calibration or is not yet calibrated. Proper calibration is essential for accurate steering angle measurements and responsive steering control.

READ MORE

This error code, XSC 523789.05, is generated when the XSC control software registers that the voltage at the output of the wheel angle sensor is too high. This condition indicates that the circuit is open, suggesting a potential issue with the sensor or its wiring.

READ MORE

This error code, XSC 523219.04, indicates that the supply voltage (BAT) at pin J2M3 has dropped below 9 volts. This low voltage condition can affect the control software’s ability to function properly.

READ MORE

This error code, XSC 523218.04, indicates that the supply voltage (BAT) at pin J2M4 has dropped below 9 volts. This low voltage condition can affect the control software’s ability to function properly.

READ MORE