The error code ETC 600006.13 is triggered by the CommandCenter (DTI) when it receives an ETC diagnostic trouble code via the CAN BUS that is not stored in the DTI memory. This “general” diagnostic trouble code enables the CommandCenter to display information relating to this unknown ETC diagnostic trouble code.

READ MORE

The error code ETC 524203.03 is triggered when the control unit recognizes an open circuit when a nonexistent function is activated in address ETC026. This indicates an incorrect configuration or wiring issue.

READ MORE

The error code ETC 523979.07 is triggered when the control unit receives the engagement signal of the rear window heater switch (S139) for too long a period of time. This indicates that the switch is jammed, defective, or there is a problem in the circuit.

READ MORE

The error code ETC 523979.05 is triggered when the control unit measures too low an amperage at the signal input of the indicator light in the rear window heater switch (S139, lead 2021). This indicates an interruption in the circuit or, on tractors without the optional “heated rear window”, an incorrect entry at input address…

READ MORE

The error code ETC 523848.13 is triggered when the air distribution adjusting motor (B132) is found to have an invalid calibration or is not yet calibrated. Proper calibration of the adjusting motor is essential for accurate control and operation within the air distribution system.

READ MORE

The error code ETC 523848.07 is triggered when the control unit receives a valid position signal from the potentiometer of the air distribution adjusting motor (B132), but the motor cannot be moved to its desired position via the motor’s connecting leads. This indicates a mechanical fault at the air distribution or an open line at…

READ MORE

The error code ETC 523848.06 is triggered when the control unit measures too high an amperage at adjusting motor connecting leads 2028 and/or 2029. This indicates a short to ground in the circuit.

READ MORE

The error code ETC 523848.05 is triggered when the control unit measures too low an amperage at adjusting motor connecting leads 2028 and/or 2029. This indicates that the circuit is open or shorted.

READ MORE

The error code ETC 523848.04 is triggered when the control unit measures 0 volts at the signal input of the potentiometer for the position of the air distribution flaps (adjusting motor B132 for air distribution, lead 2017). This indicates a short to ground in the circuit.

READ MORE

The error code ETC 523848.03 is triggered when the control unit measures a voltage in excess of 5 volts at the signal input of the potentiometer for the position of the air distribution flaps (adjusting motor B132 for air distribution, lead 2017). This indicates that the circuit is shorted to a supply lead or is…

READ MORE