This error code, SCO 520543.04, indicates that the CAN- voltage on the vehicle CAN Bus (500 kBd) is too low, suggesting a short to ground. Low voltage can prevent proper communication on the CAN Bus.

READ MORE

This error code, SCO 520542.03, indicates that the voltage of CAN+ on the vehicle CAN Bus (500 kBd) is too high, suggesting a short to 12 volts. Excessive voltage can damage the CAN Bus components and prevent proper communication.

READ MORE

This error code, SCO 520531.18, is generated when the control software receives a value for the loader bucket angle that is above the upper stop value of the return-to-position function. This indicates that the position sensor is reading values beyond the physical limits of the bucket.

READ MORE

This error code, SCO 520531.17, is generated when the control software receives a value for the loader bucket angle that is below the lower stop value. This indicates that the position sensor is reading values beyond the physical limits of the bucket.

READ MORE

This error code, SCO 520531.16, is generated when the control software receives a value for the loader bucket angle that is above the upper stop value. This indicates that the position sensor is reading values beyond the physical limits of the bucket.

READ MORE

This error code, SCO 520531.14, is generated if no front loader is connected or if no loader bucket or loader boom position sensor is detected. Proper connection and detection are necessary for the return-to-position function.

READ MORE

This error code, SCO 520531.12, indicates that the loader bucket moves in the wrong direction, suggesting a fault in the hydraulic connections. This can prevent the proper operation of the return-to-position function.

READ MORE

This error code, SCO 520531.11, indicates that there is too much of a difference between the desired and actual position of the loader bucket. This may be due to incorrect operation or configuration.

READ MORE

This error code, SCO 520531.07, indicates that the loader bucket does not reach the saved position or is blocked. This can prevent the proper operation of the return-to-position function.

READ MORE

This error code, SCO 520531.04, indicates that the voltage at the sensor input for the loader bucket position sensor is below 0.25 volts, suggesting a short to ground. Low voltage can prevent the sensor from functioning correctly.

READ MORE

This error code, SCO 520531.03, indicates that the voltage at the sensor input for the loader bucket position sensor is above 4.75 volts. Excessive voltage can prevent the sensor from functioning correctly.

READ MORE