This error code, SCO 516741.03, indicates that the voltage for the commutation valves of E-SCV XIV and E-SCV XV is too high, suggesting a circuit is open or shorted to 12 volts. Excessive voltage can damage the components and limit their functionality.

READ MORE

This error code, SCO 516460.04, indicates that the voltage for E-SCV X is below 9 volts, suggesting a short to ground. Insufficient voltage can prevent the components from operating correctly.

READ MORE

This error code, SCO 516460.03, indicates that the voltage for E-SCV X is too high, suggesting a circuit is open or shorted to 12 volts. Excessive voltage can damage the components and prevent them from functioning correctly.

READ MORE

This error code, SCO 516458.01, indicates that the supply voltage (BAT) for the stepper motor of E-SCV X has fallen below 9 volts. Insufficient voltage can prevent the stepper motor from operating correctly.

READ MORE

This error code, SCO 516458.00, indicates that the supply voltage (BAT) for the stepper motor of E-SCV X has risen above 16 volts. Excessive voltage can damage the stepper motor and prevent it from functioning correctly.

READ MORE

This error code, SCO 516457.14, indicates that the SCO control software and the SCC control software are programmed with different software versions. Incompatible software versions can lead to communication and functionality issues between the control units.

READ MORE

This error code, SCO 516455.18, indicates that both the supply voltage (BAT) is too low (9–11 volts) and the hydraulic oil temperature is between -25°C (-13°F) and -15°C (5°F).

READ MORE

This error code, SCO 516455.01, indicates that the temperature of the stepper motor for E-SCV X is below -45°C (-49°F).

READ MORE

This error code, SCO 516455.00, indicates that the temperature of the stepper motor for E-SCV X is above 100°C (212°F). The stepper motor will not become operable again until the temperature drops below 100°C (212°F).

READ MORE

This error code, SCO 516454.14, indicates a data transfer problem between the SCO control software and E-SCV X. This issue suggests a problem in the CAN Bus or in the transmitting control software.

READ MORE

This error code, SCO 516454.13, indicates that one or more of the functions in the control software are active but have not yet been calibrated. Proper calibration is necessary for the accurate operation of the selective control valve (E-SCV X).

READ MORE