This error code, SCO 002034.09, indicates a data transfer problem between the SCC control software and SCO control software. This issue suggests a problem in the CAN Bus or in the transmitting control software.

READ MORE

This error code, SCO 002006.09, indicates a data transfer problem between the SCO control software and EIC control software. This issue suggests a problem in the CAN Bus or in the transmitting control software.

READ MORE

This error code, SCO 002003.09, indicates a data transfer problem between the SCO control software and PTA (AutoPowr™/IVT™ transmission), PTQ (PowrQuad™ transmission), or PTD (DirectDrive transmission) control software. This issue suggests a problem in the CAN Bus or in the transmitting control software.

READ MORE

This error code, SCO 002000.09, is generated when a data transfer problem occurs between the ECU control unit and the SCO control software. The reception of one, several, or all of the CAN messages expected by the ECU control unit is intermittent or non-existent. This indicates a problem in the CAN BUS or in the…

READ MORE

This error code, SCO 001872.18, indicates that the voltage of the front hitch position sensor has fallen below 0.3 volts. This low voltage suggests a potential short to ground or an open circuit, which can prevent the sensor from operating correctly.

READ MORE

This error code, SCO 001872.16, indicates that the voltage of the front hitch position sensor has risen above 4.7 volts. This excessive voltage can prevent the sensor from operating correctly.

READ MORE

This error code, SCO 001872.07, indicates that the front hitch position sensor is unable to reach the saved position or is blocked. This condition can prevent the front hitch from operating correctly.

READ MORE

This error code, SCO 001872.04, indicates that the 5-volt supply voltage to the front hitch position sensor has fallen below 4.55 volts. This condition suggests a potential short to ground, which can prevent the sensor from operating correctly.

READ MORE

This error code, SCO 001872.03, indicates that the 5-volt supply voltage to the front hitch position sensor has risen above 5.25 volts. This condition suggests a potential short to 12 volts, which can prevent the sensor from operating correctly.

READ MORE

This error code, SCO 001872.02, indicates that the SCO control software cannot be calibrated due to a fault. This failure prevents proper calibration and can result in limited or no function of the front hitch.

READ MORE

This error code, SCO 000926.04, indicates that the voltage at the stepper motor input for E-SCV XIII has fallen below 9 volts. This condition suggests a potential short to ground, which can prevent the stepper motor from operating correctly.

READ MORE