This error code indicates that the voltage at channel 2 of the wheel angle sensor is above 2.25 volts. Although the value measured by the XSC control software is within the acceptable range, such a high voltage reading suggests a potential issue with the sensor or its wiring.

READ MORE

This error code indicates that the voltages in channel 1 and channel 2 of the wheel angle sensor are not in the correct ratio. The signal voltage of sensor 2 should be 1/2 of the signal voltage of sensor 1. A difference of 0.4 volts or more suggests a problem with the sensor’s accuracy, despite…

READ MORE

This error code indicates that a voltage below 0.5 volts is registered at channel 1 of the wheel angle sensor. Such low voltage readings suggest a potential issue with the sensor or its wiring, despite the XSC control software measuring the value within the acceptable range.

READ MORE

This error code indicates that a voltage over 4.5 volts is registered at channel 1 of the wheel angle sensor. Such high voltage readings suggest a potential issue with the sensor or its wiring, despite the XSC control software measuring the value within the acceptable range.

READ MORE

This error code is generated if a data transfer problem occurs between the XSC control software and the XMC control software. Reception of one, several, or all of the CAN messages transmitted by the XSC control software is intermittent or non-existent. This indicates a problem in the CAN BUS or in the transmitting control software.

READ MORE

This error code indicates a communication problem between the XMC control software and the XSC control software. Such communication issues can lead to improper functioning or a complete shutdown of certain control software functions.

READ MORE

This error code indicates a communication problem between the XMC control software and the XSC control software. Such communication issues can disrupt proper functioning and lead to a shutdown of certain control software functions.

READ MORE

This error code indicates a communication problem between the XMC control software and the XSC control software. Such communication issues can lead to improper functioning or a complete shutdown of certain control software functions.

READ MORE

This error code is generated if the duty cycle at channel 2 of the steering wheel position sensor is less than 1%. Although the value measured by the XSC control software is within the acceptable range, such a low duty cycle may suggest a potential issue with the sensor or its signal processing.

READ MORE

This error code indicates that the duty cycle at channel 2 of the steering wheel position sensor is greater than 99%. Although the value measured by the XSC control software is within the acceptable range, such a high duty cycle may suggest a potential issue with the sensor or its signal processing.

READ MORE

This error code indicates that the frequency at channel 2 of the steering wheel position sensor has fallen below 150 Hz. Although the XSC control software measures this value within the acceptable range, such a low frequency may point to issues with the sensor or its signal processing.

READ MORE