This error code is generated when the OIC control software cannot determine operator presence and, as a result, cannot provide the CAN bus with any data. A replacement value is transmitted, generating this diagnostic trouble code in the PTF control software. This fault also generates a diagnostic trouble code in the OIC control software, which…

READ MORE

This error code is generated when a data transfer problem occurs between the PTF control software and the OIC control software. The reception of one or more CAN messages expected by the PTF control software is intermittent or non-existent, which may be due to issues such as a loose wire. This indicates a problem in…

READ MORE

This error code is triggered when a fault occurs during the launch of the software. It indicates an internal error within the control software.

READ MORE

This error code indicates an internal error when reading the internal module (EEPROM).

READ MORE

This error code is generated when the ECU control software detects an open circuit to the engine speed sensor. A replacement value is transmitted, generating this diagnostic trouble code in the PTF control software. This fault also generates a diagnostic trouble code in the ECU control software, which takes priority.

READ MORE

This error code is generated when the ECU control software cannot determine the engine speed and, as a result, cannot provide the CAN bus with any data. A replacement value is transmitted, generating this diagnostic trouble code in the PTF control software. This fault also generates a diagnostic trouble code in the ECU control software,…

READ MORE

This error code is generated when a data transfer problem occurs between the PTF control software and the ECU control software. The reception of one or more CAN messages expected by the PTF control software is intermittent or non-existent, which may be due to issues such as a loose wire. This indicates a problem in…

READ MORE

This error code is generated when the PTF control software detects that the front PTO speed is too low.

READ MORE

This error code is generated when the PTF control software detects that the front PTO speed is too high.

READ MORE

This error code is triggered when the PTF control software registers that the voltage at the output of the front PTO speed sensor is too high, indicating an open circuit.

READ MORE

This error code is generated when the control software detects that the voltage at the signal input of the front PTO speed sensor is too low. This indicates a short to ground in the circuit of the front PTO speed sensor.

READ MORE