This diagnostic trouble code (DTC) UIC 524169.03 is generated when the control unit measures a voltage in excess of 4.5 volts at the signal input of the left brake pedal potentiometer. This indicates a short in or a problem with the ground connection in the potentiometer’s circuit.

READ MORE

This diagnostic trouble code (DTC) UIC 524169.02 is generated under the following conditions: Right or left brake pedal switch not actuated with a voltage of more than 1.8 volts at the left brake pedal potentiometer. Right or left brake pedal switch actuated with a voltage of less than 0.02 volts at the left brake pedal…

READ MORE

This diagnostic trouble code (DTC) UIC 524166.02 is generated under the following conditions: Right or left brake pedal switch not actuated with a voltage of more than 1.8 volts at the right brake pedal potentiometer. Right or left brake pedal switch actuated with a voltage of less than 0.02 volts at the right brake pedal…

READ MORE

This diagnostic trouble code (DTC) UIC 524109.19 is generated when the Transmission Control Unit (TCU) and Programmable Logic Controller (PLC) do not register any transmission output speed and thus cannot provide the CAN BUS with any data. A transmitted replacement value generates this diagnostic trouble code in the UIC. In its active state, this fault…

READ MORE

This diagnostic trouble code (DTC) UIC 524036.31 is generated when the control unit receives an active signal from the neutral switch that does not correspond to the position of the reverse drive lever.

READ MORE

This diagnostic trouble code (DTC) UIC 524036.01 is generated when the control unit receives an active signal from the neutral switch together with an active signal from the power zero switch.

READ MORE

This diagnostic trouble code (DTC) UIC 524032.04 is generated when the control unit receives an active signal from the tractor movement switch that does not correspond to the position of the reverse drive lever.

READ MORE

This diagnostic trouble code (DTC) UIC 524032.01 is generated when there is no active signal from the tractor movement switch and/or the power zero switch even though they should be active according to the position of the reverse drive lever.

READ MORE

This diagnostic trouble code (DTC) UIC 524030.31 is generated when the control unit receives an active signal from the reverse switch that does not correspond to the position of the reverse drive lever.

READ MORE

This diagnostic trouble code (DTC) UIC 524027.31 is generated when the control unit receives a signal from one direction switch (forward travel or reverse travel) together with the signal of the corner park switch and the power zero switch simultaneously.

READ MORE